Ahmad Azizi Mossello, Jalaluddin Harun, Hossein Resalati, Rushdan Ibrahim, Paridah Md Tahir, Seyed Rashid Fallah Shamsi, Ainun Zuriyati Mohamed


The goal of this study was to prepare soda- anthraquinone pulp from kenaf whole stem and to compare the resultant core and bast pulps for linerboard production. Pulping was done under mild cooking conditions (active alkali 12-15%) with a cooking time of 30-90 min and a temperature of 160ºC. During the pulping process, kappa numbers ranged from 56.0 to 20.6, while total yields varied from 58.4 to 54.2% with a rejection rate of 2.3 to 0.1%. Based on the quality of pulp produced, kappa numbers 49.4 and 25.4 was selected as symbolic of high and low pulps respectively. The results of the study revealed significant difference between the properties of core, whole stem (KHK and KLK), and bast pulps. Core pulps with low freeness and high drainage time the study found produced sheets with greater density, tensile index, burst index and RCT, with lower light scattering coefficient and tear index than bast pulp. Whole stem pulps showed properties between those of core and bast pulps. Moreover, KLK with high drainage time produced papers with significantly higher strength properties than KHK.


Malaysian cultivated kenaf; Soda-AQ pulp; Whole fiber; Linerboard; Fiber bonding

Full Text: PDF

Welcome to BioResources! This online, peer-reviewed journal is devoted to the science and engineering of biomaterials and chemicals from lignocellulosic sources for new end uses and new capabilities. The editors of BioResources would be very happy to assist you during the process of submitting or reviewing articles. Please note that logging in is required in order to submit or review articles. Martin A. Hubbe, (919) 513-3022,; Lucian A. Lucia, (919) 515-7707, URLs:; ISSN: 1930-2126