MECHANICAL PROPERTIES OF INJECTION-MOLDED FOAMED WHEAT STRAW FILLED HDPE BIOCOMPOSITES: THE EFFECTS OF FILLER LOADING AND COUPLING AGENT CONTENTS

Fatih Mengeloglu, Kadir Karakuş

Abstract


This study investigated the effect of filler loading and coupling agent contents on the densities and mechanical properties of injection-molded foamed biocomposites. Biocomposite pellets were manufactured using wheat straw flour, maleic anhydrite grafted polyethylene (MAPE), paraffin wax, and high-density polyethylene (HDPE) with an extrusion process. Pellets and the chemical foaming agent (azodicarbonamide) were dry-mixed and foamed in an injection-molding machine. Densities and mechanical properties of the foamed biocomposites samples were measured and analyzed using central composite design (CCD). The results showed that both filler loading and coupling agent contents affected the density and mechanical properties of foamed biocomposites. Densities in the range of 0.57 to 0.81 gr cm-3 were achieved. Best results were obtained when less than 20% wheat straw flour and 1% coupling agent content were used. The flexural modulus and tensile modulus of foamed biocomposites were improved with increasing filler loading. However, flexural strength, tensile strength, elongation at break, and impact strength values were diminished. The tensile strength of the biocomposites was positively affected by CA contents, but other mechanical properties were not affected by it. Overall, injection molded foamed biocomposites with moderate mechanical properties were produced.

Keywords


Bicomposites; Chemical foaming agent; Foaming; Coupling agent; High density polyethylene; Mechanical properties

Full Text: PDF

Welcome to BioResources! This online, peer-reviewed journal is devoted to the science and engineering of biomaterials and chemicals from lignocellulosic sources for new end uses and new capabilities. The editors of BioResources would be very happy to assist you during the process of submitting or reviewing articles. Please note that logging in is required in order to submit or review articles. Martin A. Hubbe, (919) 513-3022, hubbe@ncsu.edu; Lucian A. Lucia, (919) 515-7707, lucian.lucia@gmail.com URLs: bioresourcesjournal.com; http://ncsu.edu/bioresources ISSN: 1930-2126