The Effect of Pulp Pad Dryness in Determining Brightness using Non-Standard Fast Drying Methods

Qun Li, Zhibin He, Sundar Krishnan, Charles Lussier, Mark Woloveck, Yang Gao, M. Sarwar Jahan, Yonghao Ni

Abstract


In integrated pulp and paper mills a rapid pulp brightness determination method is needed at the pulp mill for quality and process control. In this study, the effect of dryness on the brightness reading of pulp pads has been studied. The results showed that in comparison with that from the TAPPI standard test procedure, the brightness was significantly lower when the pulp pad dryness was lower than 50%, implying that at pulp mills, the pulp pads should be dried quickly to a dryness of about 50% or higher in order to give rapid, yet reproducible brightness results. For this purpose, a forced hot air dryer was designed to dry the pulp pads to 50 to 60% dryness in about 15 minutes. The pulp pads which were dried with the forced hot air dryer had similar brightness readings to those prepared and dried by following the TAPPI standard method. Alternatively, a microwave oven can be used for the same purpose, and the pulp pads can be dried to about 50% dryness in 2.5 minutes.

Keywords


Pulp brightness; Rapid measurement; Pulp dryness; Rapid drying method

Full Text: PDF

Welcome to BioResources! This online, peer-reviewed journal is devoted to the science and engineering of biomaterials and chemicals from lignocellulosic sources for new end uses and new capabilities. The editors of BioResources would be very happy to assist you during the process of submitting or reviewing articles. Please note that logging in is required in order to submit or review articles. Martin A. Hubbe, (919) 513-3022, hubbe@ncsu.edu; Lucian A. Lucia, (919) 515-7707, lucian.lucia@gmail.com URLs: bioresourcesjournal.com; http://ncsu.edu/bioresources ISSN: 1930-2126