The Effects of Surface Roughness, Adhesive Type, and Veneer Species on Pull-Off Strength of Laminated Medium Density Fibreboard

Ihsan Kureli, Sefer Doganay

Abstract


This study investigated the pull off strengths of various laminated medium density fiberboards (MDFs). The surface roughness of the MDF, adhesive type, and veneer type were all studied. Polyvinylacetate (PVAc), urea formaldehyde (UF), and gluten were used as the adhesives for beech, pine, and oak veneers. There were a total of 216 experimental specimens that were tested according to the principles specified in the TS 5339 (1987) standard. According to the statistical analyses of the data obtained from the tests, surface roughness, veneer species, and adhesive type all affected the pull-off strength of the laminated MDF. The highest pull-off strength (2.88 N/mm2) was obtained with the MDF unsanded with 120-grit abrasive and laminated with PVAc adhesive and pine veneer. The lowest pull-off strength (1.60 N/mm2) was obtained with the unsanded MDF laminated with PVAc adhesive and oak veneer.

Keywords


Pull-off strength; Adhesive; Surface roughness; Sanding; Veneer; Medium density fiberboard (MDF)

Full Text: PDF

Welcome to BioResources! This online, peer-reviewed journal is devoted to the science and engineering of biomaterials and chemicals from lignocellulosic sources for new end uses and new capabilities. The editors of BioResources would be very happy to assist you during the process of submitting or reviewing articles. Please note that logging in is required in order to submit or review articles. Martin A. Hubbe, (919) 513-3022, hubbe@ncsu.edu; Lucian A. Lucia, (919) 515-7707, lucian.lucia@gmail.com URLs: bioresourcesjournal.com; http://ncsu.edu/bioresources ISSN: 1930-2126