Comparing Properties of North American Manufactured Particleboard and Medium Density Fiberboard - Part II: Medium Density Fiberboard

Jörn Dettmer, Gregory David Smith

Abstract


The properties of medium density fiberboard (MDF) derived from different manufacturing plants were compared. Each plant provided 5 full-sized (2440 by 1220 mm) 155-grade panels that were tested according to ANSI A208.2-2009. None of the panels met the recommended value for Internal Bond (IB). Mean values for Thickness Swell (TS) were all significantly different, with one manufacturer below the standard. Three manufacturers exceeded the recommended face Screw Withdrawal Resistance (fSWR) values, one was equal to it, and one failed. Three manufacturers exceeded the edge SWR (eSWR) standard, and the remaining two fell below. Two manufacturers met the standard for Modulus of Rupture (MOR), and only one manufacturer failed to meet the Modulus of Elasticity (MOE) requirements. Linear Expansion (LE) was evaluated for a RH change from 50 to 90%. The panels made with pMDI-resin consistently had some of the highest mean values for MOR, MOE, fSWR, and IB and exhibited good performance in the TS test.

Keywords


Medium density fiberboard; Internal bond; Mechanical properties; Thickness swell; Linear expansion; Vertical density profile; Screw withdrawal; Survey

Full Text: PDF

Welcome to BioResources! This online, peer-reviewed journal is devoted to the science and engineering of biomaterials and chemicals from lignocellulosic sources for new end uses and new capabilities. The editors of BioResources would be very happy to assist you during the process of submitting or reviewing articles. Please note that logging in is required in order to submit or review articles. Martin A. Hubbe, (919) 513-3022, hubbe@ncsu.edu; Lucian A. Lucia, (919) 515-7707, lucian.lucia@gmail.com URLs: bioresourcesjournal.com; http://ncsu.edu/bioresources ISSN: 1930-2126