Surface Quality of Milled Birch Wood after Thermal Treatment at Various Temperatures

Monika Kvietková, Milan Gaff, Miroslav Gašparík, Lukáš Kaplan, Štefan Barcík

Abstract


The surface quality of thermally modified birch wood was examined after plane milling. The surface quality was assessed based on the arithmetic mean deviation of the assessed profile Ra. Plane milling was carried out at various cutting speeds of 20, 40, and 60 m/s and feed speeds 4, 8, and 11 m/min. Based on the results, it was concluded that thermal treatment reduced the surface roughness of milled birch wood, but the decrease was not statistically significant. The cutting speed and feed had the greatest impact on all monitored factors. Increases in cutting speed reduced the average roughness, while increases in feed speed had the opposite effect. The highest roughness was achieved after plane milling with a feed speed of 11 m/min.

Keywords


Surface roughness; Thermal treatment; Birch wood; Plane milling; Cutting speed; Feed speed

Full Text: PDF

Welcome to BioResources! This online, peer-reviewed journal is devoted to the science and engineering of biomaterials and chemicals from lignocellulosic sources for new end uses and new capabilities. The editors of BioResources would be very happy to assist you during the process of submitting or reviewing articles. Please note that logging in is required in order to submit or review articles. Martin A. Hubbe, (919) 513-3022, hubbe@ncsu.edu; Lucian A. Lucia, (919) 515-7707, lucian.lucia@gmail.com URLs: bioresourcesjournal.com; http://ncsu.edu/bioresources ISSN: 1930-2126