Effect of Thermal Treatment on the Surface Roughness of Scots Pine (Pinus sylvestris L.) Wood after Plane Milling

Grzegorz Pinkowski, Andrzej Krauss, Magdalena Piernik, Waldemar Szymański

Abstract


The surface roughness in plane milled Scots pine wood that was thermally modified at 190 °C and 220 °C was examined. Indicators of wood surface roughness included the three most commonly applied parameters, arithmetic mean surface roughness (Ra), surface roughness depth (Rz), and total height of the roughness profile (Rt). Roughness was tested separately for earlywood and latewood using two feed speeds of 1 and 5 m/min. The thickness of the milled layer was 1 mm. The effect of all controlled factors, i.e., feed speed, temperature of modification, and place of measurements, on the parameters of surface roughness were statistically significant (P < 0.05). Surface roughness increased with an increase in feed speed, whereas it decreased with an increased modification temperature. Latewood was characteristically lower in roughness than earlywood. The greatest differences in homogenous groups for the determination of the roughness parameters were found in measurements taken on earlywood and latewood, while the smallest differences were recorded for different feed speeds.

Keywords


Thermal treatment; Plane milling; Roughness; Scots pine; Latewood; Earlywood

Full Text: PDF

Welcome to BioResources! This online, peer-reviewed journal is devoted to the science and engineering of biomaterials and chemicals from lignocellulosic sources for new end uses and new capabilities. The editors of BioResources would be very happy to assist you during the process of submitting or reviewing articles. Please note that logging in is required in order to submit or review articles. Martin A. Hubbe, (919) 513-3022, hubbe@ncsu.edu; Lucian A. Lucia, (919) 515-7707, lucian.lucia@gmail.com URLs: bioresourcesjournal.com; http://ncsu.edu/bioresources ISSN: 1930-2126