Effects of Some Machining Parameters on Noise Level in Planing of Some Wood Materials

Fatih Mehmet Durcan, Erol Burdurlu


Effects of type of wood, number of blades, and depth and width of cutting were evaluated relative to the noise level during the machining of wooden materials in a spindle moulder. Lombardy poplar, Oriental beech, and medium density fibreboard (MDF) materials, at the thickness levels of 6 mm, 12 mm, 18 mm, 25 mm, or 30 mm, were planed for 20 min for each variable at the feed rate of 5 meters per min and at the cutting depth of 1 mm, 2 mm, or 3 mm with one or four blades. During machining of the samples, the noise levels were measured using a noise level meter. According to the data obtained, the highest noise level connected to the type of materials was measured in the machining of poplar wood, followed by that of beech wood and MDF. As the thicknesses of the materials were increased, increases up to 9 dBA of the noise level were measured. Moreover, machining the materials with one blade instead of four and with a cutting width of 1 mm instead of 3 mm increased the noise level by 2 dBA and 6 dBA, respectively.


Wood machining; Noise emission; Occupational health and safety; Oriental beech; Medium density fibreboard (MDF)

Full Text: PDF

Welcome to BioResources! This online, peer-reviewed journal is devoted to the science and engineering of biomaterials and chemicals from lignocellulosic sources for new end uses and new capabilities. The editors of BioResources would be very happy to assist you during the process of submitting or reviewing articles. Please note that logging in is required in order to submit or review articles. Martin A. Hubbe, (919) 513-3022, hubbe@ncsu.edu; Lucian A. Lucia, (919) 515-7707, lucian.lucia@gmail.com URLs: bioresourcesjournal.com; http://ncsu.edu/bioresources ISSN: 1930-2126