Reinforcement of Poly (Lactic Acid) with Spray-dried Lignocellulosic Material

Jérôme Colson, Adriana Kovalcik, Pavel Kucharczyk, Wolfgang Gindl-Altmutter


Effects of the addition of spray-dried lignocellulosic material in polylactic acid (PLA) were evaluated in this work. The lignocellulosic material was produced by spray-drying unbleached fibrous material provided by a paper mill. Beforehand, this material was made hydrophobic in the sizing step of the papermaking process. We propose that size present on the lignocellulose powder may act as a potential alternative to commonly-used coupling agents in the compounding of cellulosic filler with PLA. The lignocellulose powder was compounded with PLA in various amounts by extrusion and injection-moulding. Homogeneous dispersion of the lignocellulose powder in PLA was achieved. However, comprehensive mechanical and microscopic characterisation revealed only minor positive effects of the filler on PLA in a limited number of cases. Further investigation by gel permeation chromatography (GPC) showed a reduction of the average molar mass of the PLA matrix with increasing filler content, partly due to the residual inorganic matter in the spray-dried powder. This effect overshadowed the homogeneous dispersion and resulted in composites with weaker mechanical properties in most cases.


Lignocellulose; Poly (lactic acid); Hydrophobic; Compatibility; Size; Extrusion; Injection-moulding; Mechanical properties; Imaging

Full Text:


Welcome to BioResources! This online, peer-reviewed journal is devoted to the science and engineering of biomaterials and chemicals from lignocellulosic sources for new end uses and new capabilities. The editors of BioResources would be very happy to assist you during the process of submitting or reviewing articles. Please note that logging in is required in order to submit or review articles. Martin A. Hubbe, (919) 513-3022,; Lucian A. Lucia, (919) 515-7707, URLs:; ISSN: 1930-2126