Processing Technology and Experimental Analysis of Gas-assisted Laser Cut Micro Thin Wood

Qingwei Liu, Chunmei Yang, Bo Xue, Qian Miao, Jiuqing Liu


Unsupported combustion nitrogen (N2) and flame-retardant helium (He) were used to facilitate laser-cutting of cherry wood, and the effects of process parameters, gas flow, and gas reactivity on the surface quality of thin wood were studied. Using identical processing parameters, the cherry wood was laser-cut with and without the added gases. Through comparing the cutting width, heat affected zone (HAZ), and surface burning conditions under different gas-assistance conditions, the influence of the added gases on the gasification and combustion of cherry wood was analyzed. When N2 gas was used, the cutting width was less than that of laser direct cutting, but the surface of the burning area did not remarkably improve. Under the same conditions, when He gas was added, the burning areas on both sides of the kerf were remarkably reduced and the consistency of kerf was good. This indicated that He gas had good oxygen isolation and flame-retardant effects. The surface of the kerf was observed with a scanning electron microscope, and addition of He gas remarkably improved the burning that occurred when cutting kerf. This study combined gas processing and laser technology, and it provided technical references for reducing post treatment improving the surface quality of laser-processed wood.


Gas assisted; Laser cutting; Quality of cutting kerf; Micromorphology

Full Text:


Welcome to BioResources! This online, peer-reviewed journal is devoted to the science and engineering of biomaterials and chemicals from lignocellulosic sources for new end uses and new capabilities. The editors of BioResources would be very happy to assist you during the process of submitting or reviewing articles. Please note that logging in is required in order to submit or review articles. Martin A. Hubbe, (919) 513-3022,; Lucian A. Lucia, (919) 515-7707, URLs:; ISSN: 1930-2126